Hot Water Boiler
The HT model is built to conform to BS2790 or any other international standards on special request.
The boiler adopts the reversal-flame principle of combustion where the hot gases make two passes within the pressurised combustion chamver and the third (final) pass through the fire-tubes to exit out to the chimney.
The combustion chamber is supported by stay bars at tis rear end. It stands clear of the boiler drum end plate, thus giving rise to the wet-back design. The design feature not only increases the heating surface of the boiler but also keeps refractory works to a minimum.
The boiler adopts the reversal-flame principle of combustion where the hot gases make two passes within the pressurised combustion chamver and the third (final) pass through the fire-tubes to exit out to the chimney.
The combustion chamber is supported by stay bars at tis rear end. It stands clear of the boiler drum end plate, thus giving rise to the wet-back design. The design feature not only increases the heating surface of the boiler but also keeps refractory works to a minimum.